A Spec Back part Swagger Rod Investiture Lead for FITTING GD
- Open trunk hatch, and pull off cover for the strut tower bolts.
– Remove the 14mm OEM nuts (requires 14mm end wrench and 5mm Allen key)
– Once removed, thread on provided nut (16mm).
– Tighten down bolt to 20lbs with 16mm End-wretch.
– Add the bracket to both sides as shown.
- Bolt it down with the OEM Honda bolt, with a thin deep socket 14mm. (Also 20lbs)
– After you are done bolting down both sides, you will add the bar onto the bracket.
– Line the bar up center to the bracket.
– Then insert the strut bar Allen bolt (8mm) through the bracket/bar and thread on nut (15mm). Tighten them to 20lbs (crush bracket to bar).
– Then tighten the bar bolt (16mm) to lock the bar in place
– Go back and tighten all bolts to 20lbs.
– You are finished!
– Take for a test drive. If there is any noise coming from the installation, go back and retighten the bolts to appropriate specs.
Get pdf A Spec Rear Strut Bar Installation Guide for FIT GD
