H1 Hummer H.I.D. High/Low Projection Headlamp Complement Electricwires as well as Designation Instructions
Installation Procession
1. Remove Batch Headlamps by stealing a three flathead screws securing headlamp bezel in place. Undo as well as drop batch headlamp.
2. Notch a behind side of a housing to acquire one more clearway for HID electricwires strap to pass by. Greatfully See Fig. 1)
3. Insert a projection HID lamps into a housing as well as reinstall Headlamp Bezel. Safeguard that the top of a HID flare is confronting up prior to securing in place.
4. Implement a dual electricwires strap to car with both black wires secured to the usual car ground as well as a dual red wires secured to the batteries certain depot post located upon drivers side engine firewall.
5. Secure a ballasts to metalcover regulating supplied self glue pads as well as sef drumming screws. CRITICAL: Be certain to secure to a outdoor sides of a metalcover in the double wall territory to safeguard a screws do not puncture by to a outside of the metalcover.
6. Check fuses to safeguard they have been commissioned rightly.
7. Track wire strap to front of engine brook as well as block a white wise upon a end of a strap to a white wise upon a behind side of a projection flare.
8. Route Red as well as Black fitting (36” in from finish of strap to the prosaic secure aspect to mountain ballast.
9. Block the black ballast wise into a counterbalance. Note: be certain which a wise is plugged in rightly, a handle can be inadvertently forced into the smallbox retrograde as well as will not work rightly.
10. Secure the handle strap with a granted zip ties.
11. Block a batch headlamp handle harness into a granted adapters and block into projection headlamp strap.
Get pdf H1 Hummer H.I.D. High/Low Projection Headlamp System Electricwires and Designation Instructions
