2004-08 Chevy Colorado/Canyon/Hummer H3/H3T 4WD Torsion Club Leveling Pack
Daystar recommends a certified technician implement this system. In addition to these instruction , professional knowledge of disassemble/reassembly procedures as good as post instructions checks contingency be known. Attempts to install this system without this believe and expertise may jeopardise the firmness and/or operating of the car.
Greatfully read all a instructions prior to beginning the installation. Check the pack hardware against the tools list. Be certain you have all the indispensable parts as well as assimilate where they go. If anything is missing, do not proceed with the designation, call Daystar Products to obtain needed items.
Installation Step:
1. Place a vehicle on a turn surface. Prior to commencement, record float height upon each side of a vehicle by measuring from the center of the spindle to a consistent indicate upon the wheel well. Record these measurements for future reference.
2. Put the transmission in Playground or 1st gear (manual transmissions) and chock a rear tires.
3. Lift the front of the car regulating the jack. Lift it sufficient to utterly unload the front suspension. Place a jack mount underneath any support rail just at the back of a reduce control arms for the front cessatio n. Ease the frame down on to the stands, but leave the slight bucket on the jack as a safety pr ecaution.
4. Verify the front tires have been off the ground and that the cessation is unloaded, or at full extension transport.
5. Locate the torsion club crossmember. There is the shaft upon each side of a crossmember that adjusts torsion bar preload. Measure or mark a exposed length of the adjuster bolt for reference during re-assembly. See Figure 1.
6. Onallsides the suitable torsion bar puller tool upon the crossmember. Be certain a top of a puller apparatus engages the recess present in most crossmembers. Also be certain a lower end of a puller tool engages a recess on a torsion key nearby the adjuster bolt. See Figure 2.
7. Fixup the torsion bar crossmember. There is a bolt upon any side of the crossmember which adjusts torsion club preload. Measure or symbol the unprotected length of a adjuster shaft for anxiety during re-assembly. See Figure 1.
8. Position a appropriate torsion bar puller tool upon a crossmember. Be sure the tip of the puller apparatus engages the recess present in many cross-members. Also be sure the lower end of the puller tool engages a recess upon a torsion key nearby the adjuster bolt.
Get pdf 2004-08 Chevy Colorado/Canyon/Hummer H3/H3T 4WD Torsion Bar Leveling Kit
