Hummer Air Valve Designation Instructions
To Implement
1. Attach a CTI Line with a pivot nut to a air valve.
2. Mislay the ?” X 20 Nyloc Bulb from the Valve
3. Put the air valve in a valve hole and hold in place.
4. Place Stainless Washer upon Inside of Wheel underneath a Nyloc Bulb.
5. Palm tighten the ?” X 20 Nyloc Nut onto a air valve.
6. Put a 9/16” open- end wrench on the swivel bulb.
7. Tighten the Nyloc bulb with the Palm Toothedwheel as well as ?” socket while land a pivot nut in place with open- finish wr ench.
8. Tighten the Nyloc nut until the O-ring on the air valve has been squeezed down to about ? or some-more of its width which equatesto that you must tighten a bulb down as distant as probable, it’s designed to bottom out on the threads of a valve, so have sure it’s “tight”.
9. Once the Nyloc nut is parsimonious, retreat a citation of the ratchet and hold which ratchet as well as Nyloc nut in place. Do Not Untighten the bulb.
10. Whilst land a ?” X 20 Nyloc nut in place, make use of the 9/16” open-end wrench as well as a tubular steel line to simultaneously, un-tighten the swivel nut from a air valve.
11. When re-installing a CTI Line, hand tighten the swivel nut on to the air valve, as well as then tie that bulb with the maximum of about 1/32 to 1/16 of a turn.
12. DO NOT over-tighten the pivot bulb, it is not necessary as it is very likely that a hand tight swivel bulb will reason air vigour, though would not indispensably stay parsimonious, so it must be slightly tightened as suggested on top of.
Get pdf Air Valve Installation Instructions
