1997-2001 Hyundai Tiburon Cold Air Complement Designation Instructions
A AEM Cold Air Systems are 50 states Street Legal Alittle model as well as years still pending) and come with complete instructions for ease of designation. Our system is constructed of lightweight aluminum and then embellished with the zirconia based powder coat for higher heat insulating characteristics. A aluminum will not crack in extended make use of similarto plastic as well as it is essentially lighter than cosmetic. The tube diameter as well as length are suited for each engine to give energy over a extended rpm operation. Distinct a plastic systems that use a ceaselessly diverging cross section, you take value of the acoustical appetite in the duct to promote cylinder filling during a intake valve-opening event.
Our Dyno testing as good as independent dyno tests (see 7/97 Competition Compress Automobile Magazine) infer that a AEM Cold Air System produces as much as twice a energy benefit than any alternative system upon the marketplace
Removing Started
a) Make certain vehicle is parked on a turn surface.
b) Set parking brake. Install rear wheel chocks.
c) Disconnect negative battery terminal.
d) If engine has run with in the past two hours let it cool down.
e) Jack the front of the car and support regulating properly rated jack stands.
f) Remove the right front circle.
Dismissal of the Stock Air Intake System Hose clamp Bolts IAT Sensor
the Unplug a Air Temp Sensor (AIT), Loosen the hose clamp, and unclip the Air Filter Lid, as well as remove it. Mislay the rubber AIT grommet, and save it for make use of with the AEM Cold Air System.
b) Disencumber a three bolts holding the Air cleanser base to a middle buffer, as well as remove it.
c) Loosen a three bolt s land the Cold Air Channel to a body, and mislay it.
