JackRabbit Ford ExplorerCompetition Trac Designation Instructions
A JackRabbit is designed to carry rainwater from the cover into the canister as well as then out through a drains. Many truck models have standard OE empty holes or plastic/rubber entrance ports in a front of a truck bed. Check to have sure your truck has the OE drain holes so that training into the piece metal is not compulsory. If training is required, be sure to check the underside of a truck bed for a most appropriate location. A holes should be located near the side as well as as distant forward as possible. Makeuseof a drill bit suitable for piece steel (such as a taper drill or step cavalcade. Cavalcade drain tube clearance holes at 3/4” (19mm). This will need to be done prior to installing a cover.
STEP 1: Remove Wrapping Plywood & Hardware
Mislay a canister from the box. Using a 3/8” wrench or socket remove a 2 bolts land a plywood on a ends of a canister. Use Side Cut Pliers to cut handle retaining straps.
Drop Plywood Packaging As well as Bolts!
STEP 2: Positioning Canister
Mislay a top cover from a canister box and set it aside for later installation. Perform a quick inventory to insure all parts are there. Be certain to check inside the small card box for tools. Use a washers, lock washers as well as bolts provided as well as attach the front rail block to any side of a lorry bed in the existing OE threaded holes approximately 4 inches from front of a truck bed. Place a Front Rail Retard angled side down opposite the lorry bed. Place the Front Rail Blocks so that the tip is level with a bed rail, afterwards tighten securely (Figure 2A) You will need one or two await pieces (We suggest regulating the top of the box the Jackrabbit was shipped in.) to set in a truck bed about asingle foot from the taxi which will go underneath a canister, raising a top of the canister above the bed rails by 2-3 inches. Remove a Canister from a box as well as set it on the support(s) in the truck bed.
STEP 3: Installing Rails
Open the rail box along a length of a box; lift rails out to equivocate scratching a rail surface on a package staples. REMOVE PROTECTIVE PAPER UPON UNDERSIDE OF RAILS. THIS IS FOR PACKAGING PURPOSES ONLY. Implement the rails by sliding them by the attached blanket guides on the canister, threading the blanket in the rails, as well as shifting the rails into the rail grips that have been attached on a inside of the canister. Afterwards slide the rails brazen, towards the lorry cab creation certain which both of the rail grips have been engaged. (Figure 3a) Secure the rail by installing the hardware (Bolt, Lock Washer, Flat Washer) through the Rail Hold Attachment and predrilled hole in the rail. Finish for both left as well as right rails.
