2005-09 Ford Mustang Back Decklid Spoiler Pack Designation Instructions
Perform this designation upon the good purify level surface for maximum safety as well as with a engine incited off.
Paint Credentials
1. Wipe any partial with cosmetic prep (Dupont® 2319 or homogeneous
2. Wipe complete part with tack fine cloth
3. Apply adhesion upholder (Dupont® 2330S or equivalent) before to tone as well as transparent coat applications. This part is made of TPO (Thermoplastic polyolefin) as well as requires the promoter for paint adhesion.
Pre-Installation
1. Wear eye insurance
2. Clean Back induce and entertain panel entirely prior to regulating cavalcade template.
Vehicle Credentials
1. Remove bureau spoiler (if not equipped skip to step 6.)
2. Open back trunk, raise decklid
3. Remove M6 nuts securing spoiler to decklid, 4 sum.
Note: Spoiler contingency be hold in place at the same time nuts are removed in order to prevent damage to car.
4. Remove spoiler from vehicle.
5. Purify old froth gasket from decklid.
6. Remove trunk liner at rear of car to benefit access to side spoiler fasteners by stealing the pushpin, 1 each side.
7. Onallsides drill templates to physique (Refer to Figure C) starting with a center spoiler template, afterwards the side templates. If the vehicle was versed with a factory spoiler, use the factory spoiler attachment holes to help align a core template to the deck lid. Refer to a alignment notes on a drill templates to bring into line the side spoiler template to the center template. Tape templates into place.
8. Transfer hole centers from template to body using automatic center punch
Center Spoiler Preporation
1. Pre-drill the 1/8” hole in the center of the noted holes. (The two outward hole locations upon a center template should be drilled by both a outer sheet steel as well as bolster portion of the deck lid using the 1/8” drill bit).
2. Use a 7/16” cavalcade bit to open up the (4) center holes in the decklid as well as use a 5/16” drill bit to open up a (2) outside hole locations, according to the template.
3. Open the rear rug lid. Regulating the outward 1/8” hole as the guide, drill the ? in access hole, with a rotor broach, into a bolster apportionment of the rug lid during a dual outward hole locations. DO NOT drill all a way through a outer piece metal upon deck lid Impute to Figure D).
