2006 CR-V Honda Music Link Installation Instructions
The information in this installation instruction is intended for make use of only by skilled technicians who have the proper tools, apparatus, and precision to correctly as well as safely supplement apparatus to your car. These procedures should not be attempted by “do-it-yourselfers.” 1. Make sure you have a anti-theft code for a airwave, afterwards write down a frequencies for the preset buttons. 2. Disconnect the negative wire from a battery. 3. Remove a center panel (release a dual self-tapping screws and 6 clips, unplug a car connector). 4. Remove a audio unit (four screws, lift a audio unit out toward you, and unplug the car connectors as well as a receiver lead). 5. Remove the passenger’s dashboard under cover (release the three clips as well as dual pins). 6. Open the glove box. Release a right as well as left stoppers (two tabs for each capsule. 7. Remove a two screws from the bottom of a glove box, and remove a glove box. 8. Route the HUBBUB connector finish of the train wire from a audio section opening to the glove box opening. 9. Secure a bus cable: Without the 14-Pin Connector: Align a bus cable 14-pin connector with a car 20-pin connector, as well as secure train wire to a car harness with a wire tie.
