Mazda Miata Shorten Your Parking Brake Lever
The NA is about as roomy as the Miata gets, though as we all know there have been limits to how comfortable a automobile can be. In my box, the parking stop lever is the major source of discomfort – see Figure 1. I’m just of average height though I have fairly prolonged legs, as well as a push rubs opposite my thigh. It can really be irritating after a whilst, so I motionless to shorten it. The procession which follows was originally developed by Paul, but I changed it a bit. The cinema are of my ’91 Miata. It took about 4 to 5 hours, though I’m the slowpoke as well as I was taking cinema. Without pictures, I could have done it in half which time.
Procedure:
1. Remove a screw (Figure 2) to apart a two halves of a side cover public from a push public, and then mislay a cover (Figure 3).
2. Remove a plastic hoop. It fits firmly and is glued upon, so I used a span of channel locks to twist it off. Wrap the towel around the hoop to protect it as shown in Figure 4 (only necessary if you wish to have the choice of regulating the bottom of a handle – see Step 17). Figure 5 shows a push with the cosmetic hoop private.
3. Unscrew the release button from a finish of a push. Remove it and a open (Figure 6). The recover rod will afterwards dump down from the blood vessel (Figure 7).
4. Remove the lever public from the automobile before stability. It’s not positively necessary to remove it – Paul didn’t – though I chose to do so for three reasons. First, it was simpler to take pictures with the assembly on my workbench. Second, I wasn’t comfortable using the hacksaw inside my car. Third, it’s much simpler to reassemble the tools as well as safeguard their proper operation on a dais. The push assembly is mounted to a floor with 3 12 mm bolts (Figure 8).
5. The stop wire composition screw, a maintaining clip and an electrical connector additionally need to be private (Figure 9). Don’t lose the shave – it prevents a screw from turning. Depress a tab upon a electrical connector (see Figure 23 to see what a connector looks similar to as well as lift it off the scoop hit. Before you remove the composition screw, make use of a screwdriver to clerk a mark during a tip of the screw (Figure 10). That way you’ll easily be means to lapse a screw to the strange position when you reinstall the lever assembly.
http://www.miata.net/garage/short_brake_lever.pdf
