2003-2007 Honda Component Bracketron Phone Mount Investiture Instructions

Begin by removing the small trim bezel that surrounds the radio. This bezel has four clips that hold it in place in each corner. Carefully use the dash trim panel tool and insert it in behind the

Muz Honda JDM Badges (S2000) Investiture Instructions

1) Use an adhesive solvent to spray the badge you are removing. Make sure you use an adhesive solvent (such as Xenit Adhesive Remover) that won’t damage the paint. 2) Once the solvent has

XR/CRF 100 120 Large Hole Apparatus Investiture Instructions

This kit is intended for use on 1993 and newer XR/CRF100’s using CDI ignition. Engine assembly requires special attention to detail. A new BBR Cylinder and piston kit have been supplied. The

Honda CRX Folding Looking-glass Element Investiture

Take care to follow the above diagram. There are two leds located on the PCB, a GREEN and YELLOW. Their purpose is to aid the initial installation. A direction change is indicated with the

2003 RSX Side Beneath Spoiler Investiture Instructions

1. Attach the left strake to the side under spoiler using the three self-tapping screws. 2. Remove the three self-tapping screws that fasten the front inner fender to the fenderwell.

2006 Honda Ridgeline PART#57600 57601 Bull Rod Investiture Instructions

PROCEDURE: 1. Remove push type retainers from lower splash shield. Remove plastic splash shield to access to mounting location. 2. Locate and remove bolts that hold the frame brace and

2004 TSX Door Visor Investiture Instructions

INSTALLATION NOTE: • These instructions are for the left door visors, the same procedure applies to the right door visors. • Be careful not to damage the glass run channels and body

2001-2007 Honda CBR600 F4i Slip-On Organized whole Investiture Instructions

Installation Instructions 1. After bike is cool make sure the bike is secured before beginning the installation. 2. Remove the right side fairing (refer to the owners manual for more

2006-09 Honda S2000 Bottom, High-Boost, and YouTune Supercharger Kits Investiture

SECTION 1: PRE-INSTALLATION PRECAUTIONS: Step 1: Remove the negative battery cable. Before removing the battery cable, verify that you have the “anti theft” radio code. It is usually located

2001 CR-V Safety Organized whole Kits Investiture Instructions

Adjusting the Control Unit • Use a small flat-tip screwdriver to change the mode switch and the horn/siren switch and to adjust sensitivity Mode Switch: • Set the mode switch

Get Adobe Flash player